- DFM - Design for Manufacturability Analysis
Thoroughly review of customers design including FAB circuit/trace routing, component positioning and spacing, potential fault reduction and process selection, and provide recommendations to enhance customer’s design, such as circuit design, mechanical design, etc. This service helps to reach the smooth and efficient manufacturing at the early stage of volume production.
- DFT – Design for Testability
Cubix’s engineering team can also help you develop the most effective test strategy to optimize the validation process and ensure maximum yield rate and maximum coverage for every product assembled within our walls.
Our test department can perform ICT, Functional, JTAG, Boundary Scan, AOI, Flying Probe, X-Ray and more, depending on your product requirements.
- BOM Analysis
Cubix systematically performs a comprehensive review of each BOM. For cost drivers, we will identify component substitutions (submit for your approval) that offer same fit, form and function at lower cost than original selected components.
- Quick Turn Prototyping
Our NPI (New Product Introduction) team can provide the fastest prototype in the business. We have dedicated production equipment and a full production team to develop your prototypes and limited runs when you are ready.